Materials / PEEK / PTFE

PEEK and PTFE (back-up and anti-extrusion)

Not elastomers: thermoplastics used with an O-ring to stop extrusion, or as seal-stack components.

Key properties

PropertyValue
ASTM D1418 designationn/a (thermoplastics)
Typical temperature range (°F)PTFE -320 to +500; PEEK to about +480
Hardness available (Shore A)n/a
RGD-rated gradesNot applicable.
Relative costLow (PTFE) to moderate (PEEK)
Typical oilfield usesBack-up rings, anti-extrusion rings, V-packing and seal-stack components.

Values are typical and vary by compound. We confirm against the actual compound datasheet on every quote.

Works well with

  • PTFE: low friction and near-universal chemical resistance
  • Glass-filled PTFE: better extrusion and creep resistance
  • PEEK: high strength and stiffness at temperature

Avoid or check carefully

  • Not a seal on its own: no elastic recovery
  • Virgin PTFE creeps (cold flow) under sustained load

Specify PEEK / PTFE for your application

Send the size or drawing and the service conditions. We confirm the compound and a quote date when your request arrives.

Scroll to Top