Materials / PEEK / PTFE
PEEK and PTFE (back-up and anti-extrusion)
Not elastomers: thermoplastics used with an O-ring to stop extrusion, or as seal-stack components.
Key properties
| Property | Value |
|---|---|
| ASTM D1418 designation | n/a (thermoplastics) |
| Typical temperature range (°F) | PTFE -320 to +500; PEEK to about +480 |
| Hardness available (Shore A) | n/a |
| RGD-rated grades | Not applicable. |
| Relative cost | Low (PTFE) to moderate (PEEK) |
| Typical oilfield uses | Back-up rings, anti-extrusion rings, V-packing and seal-stack components. |
Values are typical and vary by compound. We confirm against the actual compound datasheet on every quote.
Works well with
- PTFE: low friction and near-universal chemical resistance
- Glass-filled PTFE: better extrusion and creep resistance
- PEEK: high strength and stiffness at temperature
Avoid or check carefully
- Not a seal on its own: no elastic recovery
- Virgin PTFE creeps (cold flow) under sustained load
Specify PEEK / PTFE for your application
Send the size or drawing and the service conditions. We confirm the compound and a quote date when your request arrives.