Materials
Oilfield seal materials compared
Six materials cover nearly every oilfield duty. Pick by temperature, chemistry and pressure, or let the Seal Selector shortlist them for you.
| Material | Typical range (°F) | Strengths | Watch out for | Relative cost |
|---|---|---|---|---|
| NBR | -30 to +250 | Crude oil, hydraulic and lubricating oils; Aliphatic hydrocarbons | H2S beyond trace levels; Ozone and weathering | Lowest |
| HNBR | -25 to +300 | Hydrocarbons and crude oil; Moderate H2S at moderate temperature | Aromatic solvents and ketones; Strong acids | Moderate |
| FKM | -15 to +400 (low-temperature grades to about -40) | Hydrocarbons, including aromatics; CO2 and acid gases | Amine corrosion inhibitors; Steam and hot water | Moderate to high |
| FEPM (AFLAS) | +15 to +450 (grade dependent) | Amine corrosion inhibitors; Steam and hot water | Aromatic hydrocarbons (swelling); Ketones and chlorinated solvents | High |
| FFKM | +5 to +600 (grade dependent) | Virtually all oilfield fluids and chemicals; Sour gas, amines and steam | Cost: specify it where the duty needs it; Some fluorinated solvents | Highest |
| PEEK / PTFE | PTFE -320 to +500; PEEK to about +480 | PTFE: low friction and near-universal chemical resistance; Glass-filled PTFE: better extrusion and creep resistance | Not a seal on its own: no elastic recovery; Virgin PTFE creeps (cold flow) under sustained load | Low (PTFE) to moderate (PEEK) |
Ranges are typical and vary by compound. We confirm every recommendation against the actual compound datasheet.
NBR
The general-purpose oilfield elastomer: good with oils, hydrocarbons and water, at the lowest cost.
HNBR
The oilfield workhorse: tougher and more heat- and H2S-resistant than NBR, and the most common base for RGD-rated seals.
FKM
High-temperature hydrocarbon service and CO2, where amines and steam are not present.
FEPM (AFLAS)
The answer when amines, steam or high-pH fluids rule out FKM. AFLAS is a trademark of AGC Inc.
FFKM
Near-universal chemical resistance at the highest temperatures, for duties where nothing else survives.
PEEK / PTFE
Not elastomers: thermoplastics used with an O-ring to stop extrusion, or as seal-stack components.
Not sure which material fits?
Send the fluid, pressure and temperature. We recommend a compound and explain why on the quote.