Home / Products / Back-up Rings

Static seals

Back-up Rings

Anti-extrusion rings that let an O-ring or T-seal hold higher pressure or a larger gap. Matched to AS568 and ISO 3601 O-ring sizes, or made to your drawing.

O-ring with PTFE and PEEK back-up rings
O-ring with PTFE and PEEK back-up rings

Design

A back-up ring sits on the low-pressure side of the O-ring and bridges the extrusion gap, so the elastomer cannot be forced into it. Where pressure acts from both directions, fit one on each side.

Spiral (split) rings fit closed grooves easily; scarf-cut rings suit most radial glands; solid rings give the best extrusion resistance but need an open or split groove.

Features

  • Spiral, scarf-cut and solid designs
  • Virgin PTFE, glass-filled PTFE and PEEK
  • Sized to match AS568 and ISO 3601 O-rings
  • Contoured (concave) versions on request
  • Supplied loose or kitted with O-rings
PressureBack-up ringO-ring
Cross-section: Back-up ring on the low-pressure side of an O-ring

Technical data

TypeAnti-extrusion ring for O-rings and T-seals
MaterialsVirgin PTFE, glass-filled PTFE, PEEK
TemperaturePTFE -320 °F to +500 °F; PEEK up to about +480 °F
When to useAbove about 1,500 psi, or lower with a large gap
DesignsSpiral (split), scarf-cut, solid
SizesTo match AS568 and ISO 3601 O-rings, or to drawing
Typical values. Actual limits depend on compound, gland design and service conditions; we confirm them on every quote.

Materials

MaterialMax temperature (°F)Notes
Virgin PTFE+500Low friction, near-universal chemical resistance; can creep under sustained load
Glass-filled PTFE+500Better extrusion and creep resistance than virgin PTFE
PEEKAbout +480Highest strength and stiffness for high-pressure, high-temperature service

Sizes and standards

  • Matched to AS568 dash sizes
  • Matched to ISO 3601 metric sizes
  • Custom sizes to groove drawing

Ordering information

Include the following in your RFQ:

  • Matching O-ring size, or groove dimensions
  • Rod or piston groove, single or double-sided pressure
  • Material and design (spiral, scarf-cut or solid)
  • Quantity and required date

Applications

Wellhead & valves

High-pressure bonnet and stem seals

Downhole tools

O-ring and T-seal glands at high pressure

Hydraulics

High-pressure cylinders and valves

Need Back-up Rings?

Send the size or drawing, the service conditions and the quantity. We confirm a quote date when your request arrives.

Scroll to Top