Home / Products / T-Seals

Static seals

T-Seals

A T-shaped elastomer seal with two anti-extrusion back-up rings. It fits O-ring grooves sized for back-up rings and resists the rolling and spiral failure that O-rings can suffer in reciprocating service.

T-seal with back-up rings, cutaway view
T-seal with back-up rings, cutaway view

Design

The narrow stem of the elastomer T seals against the sliding surface, while the two back-up rings on either side of it prevent extrusion. Because the wide base locks the seal in the groove, a T-seal cannot roll or twist the way an O-ring can.

T-seals are normally installed in grooves designed for an O-ring with two back-up rings, so they can upgrade an existing O-ring gland without re-machining.

Features

  • No spiral failure or rolling in reciprocating service
  • Two back-up rings for extrusion resistance
  • Fits O-ring grooves sized for two back-up rings
  • Rod and piston versions
  • Elastomer in NBR, HNBR or FKM; back-up rings in nylon, PTFE or PEEK
Sealing surfaceElastomer T-seal (hatched) with two back-up rings
Cross-section: T-seal: elastomer T with two back-up rings

Technical data

TypeRod or piston seal, reciprocating or static
Temperature-40 °F to +400 °F, depending on elastomer and back-up material
PressureUp to about 5,000 psi typical; higher with PEEK back-up rings, depending on gap
Speed, reciprocatingUp to about 1.6 ft/s
ElastomerNBR, HNBR, FKM
Back-up ringsNylon, PTFE, glass-filled PTFE, PEEK
GroovesO-ring grooves sized for two back-up rings, or to drawing
Typical values. Actual limits depend on compound, gland design and service conditions; we confirm them on every quote.

Materials

ComponentMaterialTypical range (°F)
Elastomer TNBR-30 to +250
Elastomer THNBR-25 to +300
Elastomer TFKM-15 to +400
Back-up ringsNylonUp to about +250
Back-up ringsPTFE, glass-filled PTFEUp to +500
Back-up ringsPEEKUp to about +480

Sizes and standards

  • Sized to the matching AS568 groove (dash number)
  • Rod and piston versions
  • Custom sizes to groove drawing

Ordering information

Include the following in your RFQ:

  • Rod or piston; rod, bore and groove dimensions, or the matching O-ring dash size
  • Elastomer and back-up ring material
  • Pressure (psi), temperature (°F), fluid and stroke speed
  • Quantity and required date

Applications

Downhole tools

Packers, setting tools and sliding sleeves

Hydraulic cylinders

Rod and piston seals that resist spiral failure

Valve actuators

Reciprocating seals in compact grooves

Pumps

Plunger and piston service

Need T-Seals?

Send the size or drawing, the service conditions and the quantity. We confirm a quote date when your request arrives.

Scroll to Top